Decal Application Instructions (Wet or Dry)

Dry Application Process

1. Rub the Sticker to be sure the transfer tape is properly adhered to the sticker.

2. Clean and dry the desired area, preferably with alcohol, do not use goo gone as this could cause the application area to have a greasy surface and your decal will not securely adhere.

3. Remove the paper backing slowly making sure the sticker stays adhered to the transfer tape.

4. Carefully position the sticker to the desired area on a smooth flat surface. Once the sticker sticks it will be nearly impossible to reposition.

5. Use a hard edged object such as a credit card to make sure the entire sticker is fully adhered to the surface.

6. Slowly remove the transfer tape by folding a corner back fully pulling back the transfer tape making sure no part of the sticker remains on the tape.

7. Check for air bubbles. In most cases air bubbles can be worked to the edge of the sticker. But if not a pin hole will allow the air to come out and become virtually invisible.

8. DO NOT run your car through an automatic car wash or power wash for 72 hrs so that the decals sticky back has time to properly secure to the surface.

Wet Application Instructions

1. Rub the Sticker to be sure the transfer tape is properly adhered to the sticker.

2. Clean the desired area, do not use goo gone as this could cause the application area to have a greasy surface and your decal will not securely adhere.

3. Lightly mist area of application with a mixture with dish soap and water 1:10 ratio with a spray bottle.

4. Secure 2 corners of the decal with tape to your surface, remove the paper backing slowly making sure the sticker stays adhered to the transfer tape.

5. lightly mist the sticky surface of the decal (DO NOT SPRAY THE STICKER PAPER) this could make it difficult to remove.

6. Use a hard edged object such as a credit card to make sure the entire sticker is fully adhered to the surface start from the center working towards the edge.

7. Slowly remove the transfer tape by folding a corner back fully pulling back the transfer tape making sure no part of the sticker remains on the tape.

8. Check for air bubbles. In most cases air bubbles can be worked to the edge of the sticker with this method. But if not a pin hole will allow the air to come out and become virtually invisible.

DO NOT run your car through an automatic car wash or power wash for 72 hrs. so that the decals sticky back has time to properly secure to the surface.

Our custom decals are great for many uses such as car, truck, SUV, window, body or any other smooth flat surface.